Java project

I. POWER ELECTRONICS based SOLAR ENERGY

1. Leakage Current Suppression of Three-Phase Flying Capacitor PV Inverter with New Carrier
    Modulation and Logic Function. (IEEE 2021)
2. Modified Single-Phase Single-Stage Grid-Tied Flying Inductor Inverter with MPPT and Suppressed
     Leakage Current. (IEEE 2021)
3. High-Efficiency Two-Stage Three-Level Grid-Connected Photovoltaic Inverter (IEEE 2021)
4. A Buck and Boost Based Grid Connected PV Inverter Maximizing Power Yield from Two PV Arrays in
     Mismatched Environmental Conditions. (IEEE 2021)
5. Integrated DC–DC Converter Based Grid-Connected Transformer less Photovoltaic Inverter with
    Extended Input Voltage Range. (IEEE 2021)
6. Novel Control Method for Multimodule PV Micro inverter With Multiple Functions. (IEEE 2021)

II. POWER ELECTRONICS based WIND ENERGY

1. Analysis of a High-Power, Resonant DC–DC Converter for DC Wind Turbines (IEEE 2021)
2. A Hybrid Resonant ZVZCS Three-Level Converter for MVDC-Connected Offshore Wind Power
     Collection Systems. (IEEE 2021)

III. POWER ELECTRONICS based HYBRID SYSTEMS AND ENERGY STORAGE

1. Soft-switched Non-Isolated High Step-up Three-port DC-DC converter for Hybrid Energy Systems
    (IEEE 2021)
Stability Improvement of a Multimachine Power System Connected With a Large-Scale Hybrid Wind-
    Photovoltaic Farm Using a Super capacitor. (IEEE 2021)
3. Frequency Division Based Coordinated Control of Three-Port Converter Interfaced Hybrid Energy
    Storage Systems in Autonomous DC Microgrids. (IEEE 2021)
4. Partially-Isolated Single-Magnetic Multi-Port Converter Based on Integration of Series-Resonant
    Converter and Bidirectional PWM Converter. (IEEE 2021)
5. A Uniform Control Strategy for the Interlinking Converter in Hierarchical
    Controlled Hybrid AC/DC Microgrids. (IEEE 2021)
6. Supervisory Power Quality Control Scheme for a Grid-Off Microgrid. (IEEE 2021)
7. A Battery/Ultracapacitor Hybrid Energy Storage System for Implementing the Power Management of
    Virtual Synchronous Generators. (IEEE 2021)
8. Instantaneous Symmetrical Component Theory based Parallel Grid Side Converter Control Strategy for
    Microgrid Power Management. (IEEE 2021)

IV. POWER ELECTRONICS based INVERTER AND MULTILEVEL INVERTERS

1. A Single-Phase Single-Stage Switched-Boost Inverter With Four Switches Decentralized Control for
    Fully Modular Input-Series Output-Parallel (ISOP) Inverter System Based on the Active Power Inverse-
    Droop Method. (IEEE 2021)
2. Multistage and Multilevel Power Electronic Converter-Based Power Supply for Plasma DBD Devices.
     (IEEE 2021)
3. An Isolated Multi-Input ZCS DC–DC Front-End-Converter Based Multilevel Inverter for the Integration
     of Renewable Energy Sources. (IEEE 2021)
4. A Novel Step-Up Single Source Multilevel Inverter: Topology, Operating Principle and Modulation.
    (IEEE 2021)
5. Multi-Input Switched-Capacitor Multilevel Inverter for High-Frequency AC Power Distribution.
    (IEEE 2021)

V. POWER ELECTRONICS based WIRELESS POWER TRANSFER

1. A New Controller for Bidirectional Wireless Power Transfer Systems. (IEEE 2021)
2. High Power Density Z-Source Resonant Wireless Charger with Line Frequency Sinusoidal Charging
    (IEEE 2021)

VI. POWER ELECTRONICS based DRIVES

1.Quasi-Z-Source Indirect Matrix Converter Fed Induction Motor Drive for Flow Control of Dye in Paper
    Mill. (IEEE 2021)
2. DC-Link Capacitor-Current Ripple Reduction in DPWM-Based Back-to-Back Converters. (IEEE 2021)
3. Power Factor Correction in Modified SEPIC Converter fed Switched Reluctance Motor Drive.
     (IEEE 2021)
4. Improved Finite Control-Set Model-Based Direct Power Control of BLDC Motor with Reduced Torque
     Ripple. (IEEE 2021)
5. High-Precision Sensorless Drive for High-Speed BLDC Motors Based on the Virtual Third Harmonic
     Back-EMF. (IEEE 2021)

VII. POWER ELECTRONICS based ELECTRIC VEHICLE

1. On an Electric Scooter With G2V/V2H/V2G and Energy Harvesting Functions (IEEE 2021)
2. PV Battery Charger Using an L3C Resonant Converter for Electric Vehicle Applications. (IEEE 2021)
3. High Efficiency Bridgeless Single-Power-Conversion Battery Charger for Light Electric Vehicles.
    (IEEE 2021)
4. Implementation of a Grid-Integrated PV-Battery System for Residential and Electrical Vehicle
    Applications(IEEE 2021)

VIII. POWER ELECTRONICS based BI DIRECTIONAL CONVERTER

1. Improved Modulation Strategy Using Dual Phase Shift Modulation for Active Commutated Current-Fed
    Dual Active Bridge. (IEEE 2021)
2. A Common Ground Switched-Quasi-Z-Source Bidirectional DC–DC Converter With Wide-Voltage-Gain
    Range for EVs With Hybrid Energy Sources. (IEEE 2021)

IX. POWER ELECTRONICS based CUK AND RESONANT CONVERTER

1. Modified High-Efficiency LLC Converters With Two Split Resonant Branches for Wide Input-Voltage
    Range Applications. (IEEE 2021)
2. A Voltage Quadrupler Rectifier Based Pulse–Width–Modulated LLC Converter with Wide Output
    Range. (IEEE 2021)
3. Dynamic Modeling and Controller Design of Dual-Mode Cuk Inverter in Grid-Connected PV/TE
    Applications. (IEEE 2021)
4. Improved Power Quality Switched Inductor Cuk Converter for Battery Charging Application.
    (IEEE 2021)

X. POWER ELECTRONICS based HIGH VOLTAGE

1. Improvement of Power-Conversion Efficiency of AC–DC Boost Converter Using 1:1 Transformer.
    (IEEE 2021)
2. High-Efficiency High Step-Up DC–DC Converter With Dual Coupled Inductors for Grid-Connected
    Photovoltaic Systems. (IEEE 2021)
3. Analysis and Design of High-Efficiency Hybrid High Step-Up DC-DC Converter for Distributed PV
    Generation Systems (IEEE 2021)
4. High Step-Up Coupled-Inductor Cascade Boost DC–DC Converter With Lossless Passive Snubber.
    (IEEE 2021)
5. A Three-Winding Coupled-Inductor DC–DC Converter Topology With High Voltage Gain and Reduced
    Switch Stress. (IEEE 2021)

XI. POWER ELECTRONICS based PFC AND INTERLEAVED CONVERTER

1. Interleaved-Input Series-Output Ultra High Voltage Gain DC-DC Converter.(IEEE 2021)
2. Multitrack Power Factor Correction Architecture.(IEEE 2021)
3. Family of ZVT Interleaved Converters With Low Number of Components.(IEEE 2021)
4. New Bridgeless Buck PFC Converter with Improved Input Current and Power Factor.(IEEE 2021)
5. A Wide-Input-Range High-Efficiency Step-down Power Factor Correction Converter Using Variable
    Frequency Multiplier Technique.(IEEE 2021)

XII. POWER ELECTRONICS based SOFT SWITCHING ANG MULTIPLE OP CONVERTER

1.Analysis and Design of an Input-Series Two-Transistor Forward Converter For High-Input Voltage
    Multiple-Output Applications. (IEEE 2021)
2. An Independently Controlled Single-PWM Multiple-Output Narrow-Band Resonant Converter.
     (IEEE 2021)
3. A New ZVS Full-Bridge DC–DC Converter for Battery Charging With Reduced Losses Over Full-Load
    Range. (IEEE 2021)

XIII. POWER ELECTRONICS based Z SOURCE AND SEPIC CONVERTER

1. Isolated SEPIC DC–DC Converter With Ripple-Free Input Current and Lossless Snubber. (IEEE 2021)
2. A High Performance Impedance-Source Converter with Switched Inductor. (IEEE 2021)
3. Study on A High Voltage Gain SEPIC-Based DC-DC Converter with Continuous Input Current for
    Sustainable Energy Applications. (IEEE 2021)
4. Single-Phase Hybrid Switched-Capacitor Voltage-Doubler SEPIC PFC Rectifiers (IEEE 2021)

XIV. POWER ELECTRONICS based LED APPLICATIONS

1. Loss Analysis for Efficiency Improvement of the Integrated Buck-FlybackLED Driver.(IEEE 2021)
2. A PFC Single-Coupled-Inductor Multiple-Output LED Driver without Electrolytic Capacitor.(IEEE 2021)